Husqvarna PT26 D Operator's Manual page 47

Maintenance
IMPORTANT INFORMATION:
Never leave the propeller shaft on the machine with
one end detached. If the engine starts, damage might
occur.
2. Remove the propeller shaft completely. Pull the
ring to release the quick connector and to be able
to pull the propeller shaft from the shaft journal.
3. Start the engine and raise the cutting unit to the
transport position.
4. Stop the engine.
5. Remove the pins on both sides.
6. Lower the cutting unit to the mowing position.
When the engine has stopped: Ignition switch in
the ON position and the lever in the lowered
position within 3 seconds, otherwise turn the
ignition switch again.
7. Remove the pins from the shafts and remove the
shafts from the link joints.
8. Remove the screws for the bearing brackets.
9. Remove the adjustment screw from its mounting.
TIP! Measure where the lock nut is located on the
adjustment screw.
10. Move the cutting unit sideways to the new position.
11. Screw in the adjustment screw for the tilt angle a
few turns. Left-hand position green, right-hand
position red, see figure.
12. Move the dampers to the new position. Left-hand
position green, right-hand position red, see figure.
13. Install the bearing brackets. Left-hand position
green, right-hand position red, see figure. The
right-hand bearing bracket must be installed in the
mounting in the cover to prevent movement
against the underneath of the unit mounting' s arm.
46
Remove the propeller shaft
Remove the pins
Release the link joints
Position L green, Position R red