Jeep Wrangler 2014 Owner's Manual page 511

A tire pressure monitoring sensor is located in the spare
wheel if the vehicle is equipped with a matching full size
spare wheel and tire assembly. The matching full size
spare tire can be used in place of any of the four road
tires. A low spare tire will not cause the "Tire Pressure
Monitoring Telltale Light" to illuminate or the chime to
sound.
The "Tire Pressure Monitoring Telltale Light" will
illuminate in the instrument cluster, a "LOW TIRE
PRESSURE" message will display in the EVIC, and an
audible chime will be activated when one or more of the
four active road tire pressures are low. Should this occur,
you should stop as soon as possible, check the inflation
pressure of each tire on your vehicle, and inflate each tire
to the vehicle's recommended cold placard pressure
value. The system will automatically update and the
"Tire Pressure Monitoring Telltale Light" will extinguish
once the updated tire pressures have been received. The
vehicle may need to be driven for up to 20 minutes above
15 mph (24 km/h) to receive this information.
The "Tire Pressure Monitoring Telltale Light" will flash
on and off for 75 seconds, and will remain on solid when
a system fault is detected. The system fault will also
sound a chime. If the ignition key is cycled, this sequence
will repeat, providing the system fault still exists. A
system fault can occur by any of the following scenarios:
Base Tire Pressure Monitoring
Vehicles not equipped with EVIC will inform the driver
which tire(s) are low but not provide actual tire pressure.
The low tire ISO telltale will illuminate along with
"LoTIrE" message displayed in the ODO and then it will
scroll to which tire location is lower than the Placard
Value.
STARTING AND OPERATING 509
5