Aastra 6739i Release Note page 17

IP Phone Release Notes 3.0.1 Beta 2
Issues Resolved in Release 3.0.1
Issue Number Description of Fix
DEF20277 When configuring a 1st party and 3rd Party Bridged Line Appearance (BLA) on the phone, and then
you reboot the phone, the phone sends a NOTIFY to the first server for subscription, but does not
send a NOTIFY to the server for the resubscription.
This has been corrected. The NOTIFY is now sent for subscription and resubscription as expected.
DEF20695 During an outbound call from the Broadsoft server, after the far end is answered and the local 6739i
puts the call on hold, the local phone receives a NOTIFY hold from the server and the phone rejects
the NOTIFY message.
This has been corrected.
Usability
CLN20724 The phone went into a "No Service" state after DNS error responses were received. The phone
previously registered properly but then the "No Service" message displayed.
This has been corrected.
DEF18486 The "Switch UI Focus to Ringing Line" parameter was removed from the 6739i Aastra Web UI (at
the location Basic Settings->Preferences->General) since this functionality is no longer required for
that phone.
The 6739i phone has an incoming call pop-up with all required information that displays on the
phone's screen and allows the User to select the line for which to answer the call.
DEF18942 In some instances, the phone failed to find a Bluetooth headset when the Bluetooth search sequence
was selected.
This has been corrected. The phone finds all instances of B luetooth headsets and displays them
after a search is complete.
DEF19420 While a phone was ringing during an incoming call, the User adjusted the volume down or up. Then
the phone stopped ringing.
This has been corrected.
DEF19592 When a call was forwarded from the phone, the display did not show all the transfer information on
the screen.
The phone now displays all the relative information associated with the call that is being call
forwarded.
DEF20026 When the phone's audio is set for headset/speaker, the primary audio should be headset and the
secondary audio should be speaker (vice versa for audio setting of speaker/headset). However, in
some instances when the phone was not idle, the phone switched back to using the primary audio.
This has been corrected and the audio on the phone works properly.
DEF20047 After pressing the speaker key or lifting the handset, you get a dial tone on the line. The dial tone in
pre-dial mode stops when the phone receives an incoming call. Also, the phone doesn't ring after you
hang up the phone.
This has been corrected.
DEF20077 During a Bluetooth search on the phone, the results returned duplicate entries of the same Bluetooth
device.
This has been corrected. The phone now displays only one instance of each Bluetooth device.
14 RN-001037-00 Rev 02, Release 3.0.1