Dell Inspiron 4150 User Manual page 130

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiron 4150
NOTICE: Read
following procedure.
1. Remove the
2. Remove the display.
3. Remove the
4. Remove the
5. Remove the two M2 x 4-mm screws on the left side of the display panel and the
two M2 x 4-mm screws on the right side of the display panel.
HINT: If you have a Hitachi display panel, remove the two M2 x 4-mm screws
from the center of the left side of the display panel.
6. Remove the M2 x 4-mm screw that secures the display-feed flex cable to the
display assembly through the black plastic flex-cable retention bracket.
7. Lift the display panel from the top and rotate the display panel out of the top
cover.
8. Disconnect the bottom flex-cable connector from the inverter connector by
pulling straight up on the attached pull-tab.
file:///F|/Service%20Manuals/Dell/Inspiron/4150/display.htm (7 of 13) [2/28/2004 7:29:44 AM]
"Preparing to Work Inside the
hard drive.
display bezel.
hinge covers.
Computer" before performing the