Dell Inspiron 4150 User Manual page 126

Display, Display Assembly, Display Latch, and Hinge Covers: Dell Inspiron 4150
3. Remove the keyboard.
4. Close the display.
5. From the back of the computer, remove the five M2.5 x 5-mm screws labeled
"circle D."
6. Open the display approximately 180 degrees and support the display so that it
does not open past this position.
7. Remove the two M2 x 3-mm screws on the EMI shield bracket, which is attached
to the display-feed flex cable.
8. Remove the two M2 x 3-mm screws that secure the display-feed flex cable to
the system board.
NOTICE: When reconnecting the display-feed flex cable connector to the
system board, push down on the top-left and top-right ends of the connector.
Pressing on the center of the connector may damage resistors and compromise
EMI protection in the computer.
file:///F|/Service%20Manuals/Dell/Inspiron/4150/display.htm (3 of 13) [2/28/2004 7:29:44 AM]