Preparing The Lancing Device - Bayer HealthCare Contour next USB User Manual

Preparing the Lancing Device

Read the M ® 2 lancing device insert for complete
ICROLET
instructions. For Alternative Site Testing instructions, see
page 20.
WARNING: Potential Biohazard
The M 2 lancing device is intended for single
ICROLET
patient use only. The M
be used for assisted blood draws by health care
providers or at health care provision sites, and
should never be shared with anyone else, even a
family member due to risk of infection.
Use a new M
ICROLET
test, because it is no longer sterile after use.
14
84318354_CntrNext_USB_UG_ENca_FpBp_v1.indd 14-15 84318354_CntrNext_USB_UG_ENca_FpBp_v1.indd 14-15
2 device should not
ICROLET
® lancet each time you
1. Remove the endcap
®
from the M
ICROLET
lancing device with your
thumb on the grip indent
as shown. Snap the
endcap off from top to
bottom.
2. Loosen the round
protective cap on a
lancet by rotating it
¼ turn, but do not
remove it.
®
2
3. Insert the lancet firmly
into the lancing device
until it comes to a full
stop. This will re-set the
device. You can also
pull and release the
re-setting handle.
4. Twist off the round
protective lancet cap.
Save it for disposing of
the used lancet.
5. Replace the grey
endcap.
6. Rotate the endcap dial
to adjust the puncture
depth. The amount of
pressure applied to the
puncture site also affects
puncture depth.
15
6/26/12 10:29 AM 6/26/12 10:29 AM