Information For The User - Digigram PCX924e User Manual

PCX924e & PCX924e-Mic, PCX22e

INFORMATION FOR THE USER

This device complies with part 15 of FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a CLASS B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions contained in this data sheet, may
cause harmful interference to radio and television communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
* reorient or relocate the receiving antenna
* increase the separation between the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.
Note: Connecting this device to peripheral devices that do not comply with CLASS B
requirements or using an unshielded peripheral data cable could also result in
harmful interference to radio or television reception. The user is cautioned
that any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment. To ensure that the use of this product does not contribute to
interference, it is necessary to use shielded I/O cables.
Electrostatic discharge (ESD) can damage several components on
the board. To avoid such damage in handling the board, take the
following precautions:
Bring the device and everything that contacts it to ground potential
by providing a conductive surface and discharge paths. As a
minimum, observe these precautions:
•
•
•
•
Due to the reduced length of the PCI EXPRESS
resulting lack of mechanical stability, we strongly advise against transporting
the card(s) installed in a computer, unless its chassis or case provides a
dedicated support to keep the card securely in place in order to avoid physical
damage.
Warning:
Disconnect all power and signal sources.
Place the device on a grounded conductive work surface.
Ground yourself via a grounding wrist strap or by holding a grounded
object.
Ground any tool that will contact the device.
User manual
TM
bus connector and the
5