Information For The User - Digigram PCX880e User Manual

INFORMATION FOR THE USER

This device complies with part
1
two conditions: ( ) This device may not cause harmful interference, and (
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a CLASS B
digital device, pursuant to Part
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions contained in this data sheet, may
cause harmful interference to radio and television communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
* reorient or relocate the receiving antenna
* increase the separation between the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.
Note: Connecting this device to peripheral devices that do not comply with CLASS
B requirements or using an unshielded peripheral data cable could also result
in harmful interference to radio or television reception. The user is cautioned
that any changes or modifications not expressly approved by the party
responsible
operate this equipment. To ensure
contribute to interference, it is necessary to use
precautions:




Due to the reduced length of the PCI EXPRESS
resulting lack of mechanical stability, we strongly advise against
transporting the card(s) installed in a computer, unless its chassis or case
provides a dedicated support to keep the card securely in place in order to
avoid physical damage.
4
15
of FCC rules. Operation is subject to the following
15
of the FCC Rules. These limits are designed to
for compliance could void the user's authority to
Warning:
Electrostatic discharge (ESD) can damage several
components on the board. To avoid such damage in
handling the board, take the following precautions:
Bring the device and everything that contacts it to
ground potential by providing a conductive surface
and discharge paths. As a minimum, observe these
Disconnect all power and signal sources.
Place the device on a grounded conductive work surface.
Ground yourself via a grounding wrist strap or by holding a
grounded object.
Ground any tool that will contact the device.
that the use of this product does not
shielded I/O cables.
TM
bus connector and the
2
) This device