Table of Contents
Advertisement
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö9
HOW TO INSTALL BATTERIES
To install the batteries, follow the procedures below:
1. Slide down the cover to access
most of the remote buttons. Slide
down further to access the battery
compartment.
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed
batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible
battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufac-
turer's directions).
CELSIUS TO FAHRENHEIT CONVERSION CHART
CELSIUS
18
19
20
21
22
23
24
25
the operation mode of the remote controller
indoor unit B1
Fan
indoor unit B2
Heating
Operation
As shown above, When the "CASE I" is selected, only the indoor unit which is received the first signal from the re-
mote controller operates and the other indoor unit doesn't operate.
also, you can see the blink of indicators of the latter.
in that case, try to select one out of the "CASE II" again.
BATTERY PRECAUTIONS
FAHRENHEIT
64.4
66.2
68
69.8
71.6
73.4
75.2
77
CAUTION-IN CASE OF OPERATING TWO UNITS
CASE I
Heating
Cooling
Heating
Fan
Heating
Cooling
No Good
2. Insert two "AAA" size
Alkaline batteries follow-
ing the polarity diagram
below.
CELSIUS
26
27
28
29
30
31
32
CASE II
Fan
Cooling
Cooling
Cooling
Fan
Cooling
Good
9
TIMER
ON/OFF
ENTER/
TURBO/MILD
CANCEL
–
+
FAHRENHEIT
78.8
80.6
82.4
84.2
86
87.8
89.6
Cooling
Dehumidification
Heating
Dehumidification
Cooling
Heating
Advertisement
Table of Contents
