Operation; Connecting The Ac Cord; How To Install Batteries - Daewoo DSB-F154LH Owner's Manual

CONNECTING THE AC CORD

The outdoor unit is connected to the indoor unit through the AC connecting wire or connection cord. To connect the
indoor unit to AC, follow the procedures below:
1. Insert the attached AC
plug into a 2-pronged
Only 220V or
220V~240V AC outlet.
Plug into Only 220V or 220V~240V AC Outlet.
INFORMATION:
1. The plug shall be connected to a ground socket outlet, and the interconnection cord shall be connected by an authorized
electrician or specialist.
2. Information for interconnection cable:
3. Contact service man for the installation shall be in accordance with national wiring regulation

HOW TO INSTALL BATTERIES

To install the batteries, follow the procedures below:
1. Slide down the cover to access
most of the remote buttons.
Slide down further to access the
battery compartment.
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from pos-
sible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manu-
facturer's directions).

OPERATION

AC Outlet
and Plug
Plug into 220V AC Outlet
Items
Under 12K class
Above 12K class
BATTERY PRECAUTIONS
5
NOTES:
• Never connect the AC line cord plug to other than the speci-
fied voltage (Only 220V or 220V~240V).
• Use the attached power cord only.
• If the outlet is a 3-pronged type or other, have an electrician
install a new outlet.
• The new air conditioner system should be on it's own 220V
circuit. Contact your local electrical installer for installation.
Specifications
AC 250V, 16A, H05VV-Fx1.0m
AC 250V, 16A, H05VV-Fx1.5m
2. Insert two "AAA" size
Alkaline batteries following
the polarity diagram below.
2
2
SLEEP
TIMER
ON/OFF ENTER/
TURBO/MILD
CANCEL
+ –
– +