To Set Auto Mode; To Set Quick Mode; To Set Cool Mode - Daewoo DMB-3003LH Owner's Manual

DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö10

TO SET AUTO MODE

This unit will automatically operate the unit according to its surroundings while in the Auto mode. All you have to set is
the desired temperature and it will control the fan, coolness and dehumidifier. Follow procedures below:
1. Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and "ON" will light in the
remote display.
3. Then the unit will automatically operate.

TO SET QUICK MODE

To set this unit to cool at the highest power, follow the procedures below:
1. Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and "ON" will light in the re-
mote display.
3. The unit will then start cooling the room at the highest
power.

TO SET COOL MODE

To set the unit to cool the room to a desired temperature, follow the procedures below:
1. Press the ON/OFF button on
the remote control to turn the
unit on; the On LED will light
on the indoor unit and "ON"
will light in the remote display.
3. Using the TEMP.
temperature. The desired tem-
perature can be changed up to
32°C and down to 18°C.
AUTO
or buttons, set the desired
2. Make sure the AUTO indicator
display. Using the TEMP.
temperature. The desired temperature can be changed up
or down 1 degree from the actual
room temperature. For tempera-
ture setting: 24~28°C
AUTO
2. Press the MODE button until the Quick indicator
appears in the display.
2. Press the MODE button until the Cool
indicator appears in the display.
4. To select the fan speed, press the FAN
SPEED button until the desired speed
appears in the display (see below).
FAN SPEEDS
"AUTO" The fan will automatically select the fan speed.
" " The fan will operate on low speed.
" " The fan will operate on medium speed.
" " The fan will operate on high speed.
"NATURAL" The fan will randomly cycle through the speeds
simulating a cool breeze.
10
appears in the remote
AUTO
or buttons, set the desired