Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Daewoo DMB-3003LH
Summary of Contents for Daewoo DMB-3003LH
- Page 1 DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö20 OWNER'S MANUAL MODEL #: DMB-3003LH...
-
Page 2: Safety Instructions
If you to overtighten. require help with service, contact your certified dealer or Daewoo • Check the tubes carefully for leaks before starting the test run. Electronics for additional instructions. - Page 3 DMB-3003LH 2003.3.4 9:56 AM ∆‰¿Ã¡ˆ2 ROOM AIR CONDITIONER INSTRUCTION Remark per EMC Directive 89/336/EEC To prevent flicker impressions during the start of the compressor (technical process) following installation conditions do apply. 1. The power connection for the air conditioner has to be done at the main power distribution. This distribution has to be of an low impedance.
-
Page 4: Table Of Contents
DMB-3003LH 2003.3.4 9:57 AM ∆‰¿Ã¡ˆ3 CONTENTS It is recommended that you read the Installation and Operating instructions fully before installing and/or operating this unit. Safety Instructions............................... Contents................................Configuration ............................... Location of Controls............................Indoor Unit ...................................5 Outdoor Unit ..................................5 Remote Controller ................................7 Remote Display ...................................7... -
Page 5: Configuration
DMB-3003LH 2003.3.4 9:57 AM ∆‰¿Ã¡ˆ4 CONFIGURATION Unit A Unit B1 Unit B2 Capacity Indoor Unit Cooling (W) Heating (W) 3220 3500 2560 2490 3370 3520 2560 2490 3370 3520... -
Page 6: Location Of Controls
DMB-3003LH 2003.3.4 9:57 AM ∆‰¿Ã¡ˆ5 LOCATION OF CONTROLS INDOOR UNIT (Cold or hot) Air Out OUTDOOR UNIT Service Cover Remove this cover to access the AC connection from this unit to the indoor unit. Service Valve The indoor units and outdoor... -
Page 7: Indoor Unit Display
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö6 INDOOR UNIT DISPLAY Indoor Unit Display Switch Panel Remote Control Signal Receiver This place is the part to receive the signal if it receives the signal, you can hear the signal “beep”. EMR. REMOCON Timer (Yellow) -
Page 8: Remote Controller
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö7 REMOTE CONTROLLER DMB-3003LH Display AUTO Displays information pertaining to unit. ON/OFF Button (Red) Press to turn the unit on or off. TEMPERATURE Buttons Press to raise or lower FAN SPEED Button the desired temperature. Press to select the fan speed (High "... -
Page 9: Operation
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö8 OPERATION CONNECTING THE AC CORD Only the power plug of outdoor unit is connected to AC outlet, and the power of indoor units were supplied with AC con- nection cords from outdoor unit. To supply the system with AC power, follow the procedures bellow: 1. -
Page 10: How To Install Batteries
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö9 HOW TO INSTALL BATTERIES To install the batteries, follow the procedures below: TIMER 2. Insert two “AAA” size 1. Slide down the cover to access ON/OFF ENTER/ most of the remote buttons. Slide Alkaline batteries follow-... -
Page 11: To Set Auto Mode
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö10 TO SET AUTO MODE This unit will automatically operate the unit according to its surroundings while in the Auto mode. All you have to set is the desired temperature and it will control the fan, coolness and dehumidifier. Follow procedures below: 1. -
Page 12: To Set Only Fan Mode
TO SET ONLY FAN MODE To operate only the fan so the unit will circulate the air, proceed as follows: 1. Press the ON/OFF button on the remote control to 2. Press the MODE button until the Fan indicator turn the unit on; the On LED will light on the indoor appears in the display. -
Page 13: To Set Heat Mode
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö12 TO SET HEAT MODE To set the unit to heat the room to a desired temperature, follow the procedures below: 1. Press the ON/OFF button on the remote control to 2. Press the MODE button until the Heat indicator turn the unit on;... -
Page 14: To Set On Timer Mode
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö13 TO SET ON TIMER MODE This unit can be set to automatically turn on after a predetermined amount of hours (up to 24) in the order of 0.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 5, 6, 8, 10, 12, 16, 20, 24. -
Page 15: To Set Sleep Mode
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö14 TO SET SLEEP MODE When you are going to sleep, select this feature and the unit will cool off the room to the desired temperature and then increase that temperature throughout the night. 1. Press the ON/OFF button on the 2. -
Page 16: Installation Diagram
INSTALLATION DIAGRAM Below is an overview for the connection of the Indoor unit to the Outdoor unit. The pages following will give detailed instructions for full installation. Remember to read the complete Installation section and follow all the safety instructions fully when installing the Indoor and Outdoor units. -
Page 17: Ac Connection Diagram
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö16 AC CONNECTION DIAGRAM You should individually connect wires to terminals as bellow diagram: Terminal Block Terminal Block Terminal Block Indoor Unit B2 Indoor Unit B1 Indoor Unit A Connection Connection Connection Cable Cable Cable Power... -
Page 18: Changing/Cleaning The Air Filters
CHANGING/CLEANING THE AIR FILTERS To change or clean the two black air filters, follow the procedures below: 1. Open the indoor unit’s 2. Remove the two small cover and remove both filters (Deodorizing and black air filters by bending Electrostatic) from the them slightly backward indoor unit. -
Page 19: Care And Maintenance
CARE AND MAINTENANCE warning • Make sure the AC cord is unplugged and the unit is off before cleaning. • Do not use water on the unit to clean it. This is a shock hazard and the unit can be damaged. Clean the casing and front of the indoor unit with a vacuum brush or wipe with a clean damp cloth. -
Page 20: Troubleshooting Guide
DMB-3003LH 2003.3.4 9:57 AM ÆäÀÌÁö19 TROUBLESHOOTING GUIDE Before requesting service, please refer to the chart below for possible solutions: SYMPTOMS POSSIBLE CAUSE POSSIBLE SOLUTIONS No power Power failure. Restore the power Line voltage too low. Contact electrician to install new outlet.