Table of Contents
Advertisement
4. OPERATING ADJUSTMENTS
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fi xture is DMX, which appears as
Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to
choose a channel between
2.) To change between 3 and 6 channel DMX mode, select
<ENTER>. Select either
fi rm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units. It may be necessary to use a terminator at the
last fi xture. For more information about terminators, see page 8.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
be the fi rst unit. Finally, chain the units together using DMX cable.
Master
3.) Select slave function by using the <UP>/<DOWN> keys to reach SLAV in
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
4.) On the master fi xture, use the <UP>/<DOWN> keys to reach SHND, which
allows you to select the Master/Slave mode.
Sound active
Auto mode
Color preset
To set a custom color in Master/Slave / Standalone Mode:
Using this function, you can adjust the intensity of LED segments 1, 2 and 3 using the Red,
Green and Blue values from 0-255. You can also use this function to adjust the overall
maximum intensity of the fi xture in any mode.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this
mode.
NAnu
1.) Select
rEd, GrEE
2.) Choose
3.) Using the <UP>/<DOWN> keys, select the color you wish to display by
varying Red/Green/Blue intensity between 0 and 255, then hit <ENTER> to
confi rm each color choice.
4.) Select Color preset mode as instructed above, then select
<ENTER> to confi rm.
To Show the Fixture Running Hours:
FhrS
1.) Select
The Puck: CSI Manual Rev. A
1
512
and
. Press <ENTER> again to confi rm.
6Ch
3Ch
or
, then press <ENTER> again to con-
SLNd
NASt
then
SLNd
SLAu
then
SoUn
then <ENTER> to confi rm.
CoLo
Auto,
then
CoLo
CoL 1 - CoL 7,
then
from the control panel, then hit <ENTER>.
bLuE
or
, then hit <ENTER> to confi rm.
from the control panel, then hit <ENTER> to confi rm.
Page 8
Addr
on the LED
ChNd,
then press
to confi rm.
to confi rm.
then <ENTER> to confi rm.
<ENTER>.
CoL 7.
then
Copyright (c) 2011 Blizzard Lighting, LLC
Advertisement
Table of Contents
