Smart Card Reader Board - HP Compaq 6910p Maintenance And Service Manual

Reverse this procedure to install the top cover.

Smart card reader board

Description
Smart card reader board
Before removing the smart card reader board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC Adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
MultiBay II device (see
b.
Keyboard (see
c.
Switch cover (see
d.
Display assembly (see
e.
Top cover (see
f.
Remove the smart card reader board:
Remove the three Phillips PM2.5×4.0 screws (1) that secure the smart card reader board and the
1.
PC Card assembly to the base enclosure.
Battery on page 42).
Hard drive on page 46)
MultiBay II device on page
Keyboard on page 57)
Switch cover on page
Display assembly on page
Top cover on page 76)
56)
64)
71)
Component replacement procedures
Spare part number
446793-001
79