HP Compaq 6910p Maintenance And Service Manual page 63

Lift the front edge of the WLAN module compartment cover (2), swing it toward the back of the
2.
computer, and remove the cover. The WLAN module compartment cover is included in the Plastics
Kit, spare part number 446439-001.
Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
3.
NOTE: The black WLAN antenna cable is connected to the WLAN module "Main" terminal. The
white WLAN antenna cable is connected to the WLAN module "Aux" terminal. If the computer is
equipped with an 802.11a/b/g/n WLAN module, the yellow WLAN antenna cable (2) is
connected to the middle terminal on the WLAN module.
Remove the two Phillips PM2.0×3.0 screws (3) that secure the WLAN module to the computer. (The
4.
edge of the module opposite the slot rises away from the computer.)
Remove the WLAN module (4) by pulling the module away from the slot at an angle.
5.
NOTE: WLAN modules are designed with a notch (5) to prevent incorrect installation.
Reverse this procedure to install the WLAN module.
Component replacement procedures 55