Smart Card Reader Board - HP ZBook 17 G3 Maintenance And Service Manual

Smart Card reader board

Description
Smart Card reader bracket (part of the plastics kit)
Smart Card reader board
Before removing the Smart Card reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Remove the battery (see
Remove the Smart Card reader board:
1. Remove the three screws (1) that secure the Smart Card reader bracket to the computer.
2. Release the cable (2) from the guides securing it.
3. Remove the bracket (3).
4. Open the ZIF connector (1) on the system board to release the Smart Card board ribbon cable.
5. Carefully lift the ribbon cable (2) to release it from the adhesive securing it to the computer.
6. Remove the two Phillips screws (3) that secure the board and the plastic guide to the computer.
52 Chapter 6 Removal and replacement procedures for authorized service provider parts
Service door on page
Battery on page 34).
33).
Spare part number
850117-001
848373-001