Smart Card Reader Board - HP ZBook 15u G3 Maintenance And Service Manual

Smart card reader board

Description
Smart card reader board (not available with mobile workstation)
Smart card reader board (mobile workstation only)
Before removing the card reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive
c. Internal base plate
d. NFC module (see
Remove the smart card reader board:
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
installed.
1. Disconnect the cable from the board (1).
2. Disconnect the cable from the touchpad (2).
Bottom cover on page
Battery on page
Keyboard on page 50)
(Hard drive on page 41)
(Internal base plate on page
NFC module on page
35).
40).
56)
68)
Component replacement procedures
Spare part number
821167-001
821188-001
69