Precor P80 Operating And Maintaining page 107

Assembling the Treadmill
3. Pass the lower end of the television cable through the
4. Pass the lower end of the Ethernet cable through the
5. Fit the lower ends of any optional console cables into the
6. Place the jack panel over the opening and replace the two
right-hand grommet and attach its F-type connector to
the connector on the inward side of the jack panel. Using
a ⁷ ₁₆-inch torque wrench, tighten the connectors to 30
in-lb.
right-hand grommet and snap it into the eight-pin
modular coupler installed in the jack panel.
notch in the upper edge of the jack panel.
machine screws. Tighten the screws completely.
Figure 9: Accessory jack panel installation
29