For hard drive connector locations, see "System board components (on page 8)."
Connect and route the cables.
6.
Install the access panel (on page 13).
7.
Install the server blade
8.
Memory option
You can expand server memory by installing PC2-5300 Registered DDR2 SDRAM DIMMs. The server
supports up to 128 GB of memory using 16 8-GB DIMMs (eight DIMMs per processor).
NOTE:
protection beyond Advanced ECC. By default, the server is set to Advanced ECC Support. For
more information, refer to "HP ROM-Based Setup Utility (on page 40)."
For DIMM slot locations and bank assignments, see "System board components (on page 8)."
("Installing a server
The Advanced Memory Protection option in RBSU provides additional memory
blade" on page 17).
Hardware options installation 20