Installing A Memory Module; Installing A Processor - HP ProLiant DL160 G6 Installation Sheet

Figure 8 Removing the Top Cover
Installing a hard drive
The drive bays on the front panel can accommodate two hot-plug
hard drives, four hot-plug hard drives, or four non-hot-plug hard
drives. You can install either SAS hard drives or SATA hard drives in
the server.
CAUTION: Drives can be damaged by static electricity.
Before handling drives, touch an unpainted metal surface
to discharge static electricity.
To install the hot-plug hard drive:
1. Push the hard drive assembly into the drive bay until it stops.
2. Press the hard drive carrier latch inward until it clicks.
Figure 9 Installing the Hot-plug Drive
To install the non-hot-plug hard drive:
1. Put the non-hot-plug hard drive disk into the carrier.
2. Fasten the hard drive to the carrier using the screws (two on
each side).
Figure 10 Installing the Non-hot-plug Hard Drive into the Carrier
3. Remove the hard drive blank from front of system if installed.
4. Push the hard drive assembly into the drive bay until it stops.
Figure 11 Installing the Non-hot-plug Hard Drive Assembly
5. Fasten the screw with the T-10/T-15 wrench provided to secure
the hard drive to the chassis.
Figure 12 Fastening the Screw
6. Connect the cabling from the SAS connector on the system
board to the drives using the cables provided.

Installing a memory module

• Installation guide for 1P configuration:
o Follow the sequence of 3A, 6B, 9C, 2D, 5E, 8F, 1G, 4H,
and 7I for the corresponding processor when installing the
memory.
• Installation guide for 2P configuration:
Follow the sequence of 3A, 6B, 9C, 2D, 5E, 8F, 1G, 4H,
o
and 7I for the corresponding processor when installing the
memory.
o Install at least one memory DIMM for each processor.
The memory quantity installed for each processor can be
o
different.
Figure 13 DIMM Population
CAUTION: DIMMs can be damaged by improper
handling. Always use an anti-static wrist strap and
grounding mat, and discharge static electricity before
touching DIMMs.
NOTE: Refer to "System board components" in this
document for the DIMM locations.
To install the memory module:
1. Align the notch on the bottom edge of the memory module with
the keyed surface of the DIMM slot and then fully press the
memory module into the slot until the holding clips snap back in
place.
Figure 14 Installing the Memory Module
CAUTION: DIMM slots are structured to ensure proper
installation. If you insert a DIMM but it does not fit easily
into the slot, you may have inserted it incorrectly. Reverse
the orientation of the DIMM and insert it again.

Installing a processor

CAUTION: If upgrading the system to 130W
processors, system fan configuration must be updated to
ensure proper system thermal performance. Fan
configurations are detailed in the server Maintenance
and Service Guide, available from the HP website at
http://www.hp.com/.
To install the processor:
CAUTION: Failure to completely open the processor
locking lever prevents the processor from seating during
installation, leading to hardware damage.
1. Open the processor locking lever and the processor
socket retaining bracket. Do not remove the processor
socket cover.