Installing A Secondary Flash Memory Module - HP t5740e - Thin Client Hardware Reference Manual

2. To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
Figure 2-8
3. To insert the new battery, slide one edge of the replacement battery under the holder's lip with
the positive side up. Push the other edge down until the clamp snaps over the other edge of the
battery (2).
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and
rechargeable batteries. For more information about recycling programs, go to www.hp.com/recycle.

Installing a Secondary Flash Memory Module

Before beginning the installation process, review
on page 11
WARNING!
side access panel, ensure that the thin client is turned off and the power cord is disconnected from
the electrical outlet.
18 Chapter 2 Hardware Changes
Removing and replacing the internal battery
Batteries, battery packs, and accumulators should not be disposed of together with the general
household waste. In order to forward them to recycling or proper disposal, please use the public
collection system or return them to HP, an authorized HP partner, or their agents.
The Taiwan EPA requires dry battery manufacturing or importing firms, in accordance with Article 15 or
the Waste Disposal Act, to indicate the recovery marks on the batteries used in sales, giveaways, or
promotions. Contact a qualified Taiwanese recycler for proper battery disposal.
for procedures you should follow before and after installing or replacing hardware.
You must remove the right side panel to access the system board. Before removing the
General Hardware Installation Sequence
ENWW