PC
Connection
To Install as
a Master
Drive
11
The CD-R/RW drive connects to the motherboard of the host
computer using an IDE interface cable. You may connect the CD-
R/RW Drive as a Slave or Master device, depending on your computer.
To install the drive as a Master, the jumper can be left as supplied
from the factory.
Master drive
(Booting hard disk)
Primary
connector
Master drive
(Booting hard disk)
Primary
connector
NOTE : A hard disk is normally installed as the Primary Master on
the EIDE (ATAPI) interface. Other EIDE peripheral devices such as
hard drives and CD-ROMs are then set differently.
Master drive
(CD-R/RW drive)
- OR -
Master drive
(CD-R/RW drive)
Slave drive
(Other IDE drive)
Secondary
connector
Motherborad
Secondary
connector