Honda CR250R Owner's Manual & Competition Handbook page 40

Refueling Procedure
Fuel Tank Capacity:
2.0 US gal (7.7R)
(3)
(1) fuel fill cap (3) steering stem nut
(2) breather tube
1. To open the fuel fill cap (1), pull the breather
tube (2) out of the steering stem nut (3). Turn
the fuel fill cap counterclockwise and remove
it.
2. Add fuel until the level reaches the bottom of
the filler neck. Avoid overfilling the tank.
There should be no fuel in the filler neck.
3. Close the fuel fill cap and insert the breather
tube to the steering stem nut.
WARNING
Gasoline is highly flammable and
explosive. You can be burned or
seriously injured when handling fuel.
• Stop the engine and keep heat, sparks
and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Fuel Line
(2)
(1)
(1)
(1) fuel valve
1. Check the fuel valve (1) and fuel filter for
contamination.
2. Check for leaks.
3. Check the fuel line (2) for cracks,
deterioration, damage, or leakage. Replace the
fuel line, if necessary.
4. Check for interference between the frame and
tank and adjust if necessary.
Fuel Filter
The fuel filter is included in the fuel valve
mounted on the bottom left side of the fuel tank.
Dirt accumulated in the filter will restrict the
flow of the fuel to the carburetor.
To service the fuel filter:
1. Drain the fuel from the fuel tank into an
(2)
2. Remove the fuel valve (1) by removing the
(2) fuel line
(1) fuel valve
(2) bolt
3. Reassemble the fuel valve in the reverse order
Fuel System
approved gasoline container. Disconnect the
fuel line.
bolts (2). Wash the fuel filter (3) in high
flash-point cleaning solvent.
(4)
(3)
(1)
(3) fuel filter
(4) O-ring
of removal. Make sure the O-ring (4) is in
place. Install the fuel valve in the fuel tank.
Refill the fuel tank.
Attach the fuel line and turn the fuel valve to
ON; check for leaks.
Servicing Your Honda
(2)
35