Multiple Image Services; Firmware Information - D-Link DGS-3324SRi User Manual

Multiple Image Services

The Multiple Image Services folder allows users of the xStack family of switches to configure and view information
regarding firmware located on the Switch. The Switch allows two firmware images to be stored in its memory and either
can be configured to be the boot up firmware for the Switch. For information regarding firmware images located on the
Switch, open the Firmware Information link. The default setting for the Switch's firmware will have the boot up
firmware stored in Image 1, but the user may set either firmware stored to be the boot up firmware by using the Config
Firmware Image window.

Firmware Information

The following screen allows the user to view information about current firmware images stored on the Switch. To access
the following screen, click Maintenance > MULTIPLE IMAGE Services > Firmware Information.
This window holds the following information:
Parameter
BOX
ID
Version
Size
Update Time
From
xStack Stackable Gigabit Layer 3 Switch Manual
Figure 10- 5. Firmware Information window
Description
States the stacking ID number of the switch in the switch stack.
States the image ID number of the firmware in the Switch's memory. The Switch can
store 2 firmware images for use. Image ID 1 will be the default boot up firmware for
the Switch unless otherwise configured by the user.
States the firmware version.
States the size of the corresponding firmware, in bytes.
States the specific time the firmware version was downloaded to the Switch.
States the IP address of the origin of the firmware. There are five ways firmware may
be downloaded to the Switch.
R – If the IP address has this letter attached to it, it denotes a firmware
upgrade through the Console Serial Port (RS-232).
286