Using Your Ceiling Fan - Emerson AMHURST CF880BS00 Owner's Manual

54" ceiling fan

Hide thumbs Also See for AMHURST CF880BS00:

Owner's manual (21 pages)

Table Of Contents

Table of Contents

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the outlet box and

not pinched between the ceiling cover and the ceiling.

1. Push the wires and connectors up into the outlet box

while inserting the receiver fully into the hanger

bracket.

2 Position the antenna wire on top of the receiver.

3. Screw the two threaded studs (supplied) into the

tapped holes in the hanger bracket.

4. Lift the ceiling canopy up to the threaded studs and

turn until studs protrude through the holes in the

ceiling canopy (Figure 16).

5. Secure the ceiling canopy in place by sliding

lockwashers over the threaded studs and installing

the two knurled knobs (supplied). (Figure 16).

Tighten the knurled knobs securely until the ceiling

canopy fits snugly against the ceiling and the hole in

the ceiling canopy is clear of the downrod.

General

This control is designed to operate only one ceiling fan

6. Before disconnecting power, ensure that the fan is

set at the highest speed.

NOTE: Electric connections should be in

accordance with the National Electrical Codes and

all Local Codes. Before starting, disconnect power

to the circuit at the fuse box or circuit breaker

panel.

7. Remove the faceplate and screws from the existing

wall switch. Pull switch out from wall outlet box

(Figure 17).

8. Disconnect wire from existing fan wall switch.

Setting Operating Frequency of

Wall Control

Your wall control has code switches which must be set

in one of 32 possible code combinations. The five levers

(numbered 1, 2, 3, 4, and 5) on the switches are factory-

set in the ON (up) position (Figure 18). Change the

switch settings as follows:

9. Slide the five switch levers in the wall control to your

choice of ON (up) or down positions. Use a ball-

point pen or small screwdriver and slide the levers

firmly up or down.

10. When the power is restored after installation, push

and hold the fan off button (

to set the code in the receiver.