2
After you log in, use the Basic Setup page to configure the
modem so it can connect with your Internet service provider.
Do the following:
a
Enter your Protocol, Encapsulation, VPI, and VCI
settings in the appropriate boxes. Your service provider
should supply these values. If you do not know these
settings, refer to the tables starting on page 93.
b
NAT (Network Address Translation) is Enabled by
default. This feature lets multiple users access the Internet
sharing a single IP address. Enabled is typically the right
setting. Select Disable in the unlikely event that you want
to assign different public IP addresses to each network
user.
14
ADSL X6 User Guide