Step 2 Select Screws, Washers, And Spacers - RocketFish RF-TVMFM02V2 Assembly Manual

RF-TVMFM02V2 TV Wall Mount

Step 2 Select screws, washers, and spacers

1 Select the hardware for your TV (screws, washers, and spacers). A limited number of TVs come with
mounting hardware included. (If there are screws that came with the TV, they are almost always in the holes
on the back of the TV.) If you don't know the correct length and diameter of the mounting screws your TV
requires, test various sizes by hand threading the screws.
Select one of the following types of screws:
M4 × 12 mm screws (G)
M4 × 35 mm screws (H)
M5 × 12 mm screws (L)
M5 × 35 mm screws (M)
Select one of the following types of washers:
M4/M5 washers (I)
For an irregular or obstructed TV back, use the following spacers:
CAUTION: To avoid potential personal injuries and property damage, make sure that there are adequate
threads to secure the brackets to your TV. If you encounter resistance, stop immediately and contact
customer service. Use the shortest screw and spacer combination to accommodate your TV. Using hardware
that is too long may damage your TV. However, using a screw that is too short may cause your TV to fall from
the mount.
Screw is
Screw is
too long
too short
2 Remove the screws.
3 For a flat back TV, go to "Step 3 Install the vertical TV brackets - Option 1: Installing for a TV with a flat back"
on page 8.
-OR-
For an irregular or obstructed back, go to "Step 3 Install the vertical TV brackets - Option 2: Installing for an
irregular or obstructed back" on page 9.
Universal spacers (K)
Screw fits
correctly
Need help? Call 800-620-2790
M6 × 12 mm screws (N)
M6 × 35 mm screws (O)
M8 × 16 mm screws (P)
M8 × 20 mm screws (Q)
M8 × 35 mm screws (R)
M6/M8 washers (J)
7