Select Screws, Washers, And Spacers - RocketFish RF-HTLF23 Assembly Manual

STEP 2 - Select screws, washers, and spacers
1 Select the hardware for your TV (screws, washers, and spacers). A limited number
of TVs come with mounting hardware included. (If screws came with your TV,
they are almost always in the holes on the back of your TV.) If you don't know the
correct length of the mounting screws your TV requires, test various sizes by
hand threading the screws.
Select the screws that fit:
M6 × 12 mm screws (01)
M6 × 35 mm screws (01)
M8 × 16 mm screws (01)
Use the M6/M8 washers (02) for all screws.
For an irregular or obstructed TV back, also use the 2.5 mm or 22 mm
spacers ( ).
03
CAUTION: To avoid potential personal injuries and property damage,
make sure that the screws have adequate threads to secure the brackets
to your TV. If you encounter resistance, stop immediately and contact
customer service. Use the shortest screw and spacer combination to
accommodate your TV. Using hardware that is too long may damage your TV.
However, using a screw that is too short may cause your TV to fall from the mount.
Screw fits
correctly
2 Remove the screws.
3 For a flat back TV, go to STEP 3 - Option 1: Attaching the horizontal brackets to a
TV with a flat back on page 10.
-OR-
For an irregular or obstructed back, go to STEP 3 - Option 2: Attaching the
horizontal brackets to a TV with irregular or obstructed back on page 11.
Need help? Call 1-800-620-2790 (U.S. and Canada)
M8 × 25 mm screws (01)
M8 × 35 mm screws (01)
M8 × 50 mm screws (
Screw is
too long
RF-HTLF23
)
01
Screw is
too short
9