Step 6 -Option 1 - Install The Wall Plate To A Wood Stud Wall - RocketFish RF-TVMFM02V2 Assembly Manual

Step 6 -Option 1 - Install the wall plate to a wood stud wall

Note: Drywall covering the wall must not exceed 5/8" (16 mm).
1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder and mark the center.
2 Align the wall plate template (E) at the height you determined in the previous step and make sure that it is
level. Tape the wall plate template to the wall, then use a pencil to mark the lag bolt hole locations (2).
Remove the wall plate template.
3 Drill pilot holes to a depth of 3" using a 7/32" diameter drill bit.
4 Align the arm assembly (A) with the pilot holes, then place the lag bolt washers (S) over the holes in the arm
assembly (A). Insert the lag bolts (T) through the washers, then tighten the lag bolts with the socket wrench
only until the washers (S) are firm against the arm assembly.
CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (T).
Wall
9.72 in. (246.9 mm)
Full
extension
6.99 in.
(177.5 mm)
Note: Minimum wood stud size:
common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1.5 x 3.5 in.)
You'll need
T (2)
S (2)
Level
12
Note: TV shifts 6.99 in. (177.5 mm)
Home
position laterally from the home position to
full extension.
1
3
75 mm
Pencil
Arm
Template (E)
assembly (A)
Tape
Need help? Call 800-620-2790
RF-TVMFM02V2 TV Wall Mount
2
4
3 in.
75mm
3 in.
Edge-to edge
Drill
stud finder
E
A
T
S
7/32" wood
1/2" socket
drill bit
wrench