Basic Operation; Turning On The Projector - Eiki LC-XB43N Owner's Manual

Basic Operation
1
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.

Connect the projector's AC power cord into an AC
outlet. The POWER indicator lights red. Open the slide
shutter (see pages 9, 65).
3
Press the ON/STAND-BY button on the top control or
on the remote control. The POWER indicator lights
green and the cooling fans start to operate. The
preparation display appears on the screen and the
count down starts.
4
After the countdown, the input source that was selected
the last time and the lamp control status icon (see page
57) appear on the screen.
5
If there is no signal input when start on the projector,
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point ▲▼ buttons
and press the SELECT button. And then follow the
input signal guidance window to correct the signal and
connection.
If the projector is locked with a PIN code, PIN code input
dialog box will appear. Enter the PIN code as instructed
on the next page.
Note:
• When the Logo select function is set to Off, the logo will
not be shown on the screen (p.51).
• When Countdown off or Off is selected in the Display
function, the countdown will not be shown on the screen
(p.51).
• When the Input Search function is set to On, the input
signal will be searched automatically (p.49).
• When Off is selected in the Display function, the Video/
PC selection window and the input signal guidance
window are not shown on the screen (p.51).
• If you press the ON/STAND-BY button on the top
control or the remote control during the countdown
period, you can skip the countdown and go to the
normal operations.
In this case, however, the brightness of the image needs
some time to stabilize after turning on the projector.
The display may flicker after turning on the lamp for the
characteristics of the lamp.This is normal operation and
not a malfunction.
Turning On the Projector
16
http://www.eiki.com
The preparation display will disappear
after 30 seconds.
Selected Input Source and Lamp Control
Video
Lamp control status
(See page 57 for Lamp control status.)
Note:
The Filter warning and Lamp replacement icons
may appear on the screen depending on the
usage state of the projector.
Video / PC selection window
Input signal guidance window
No signal
Current Input setting: Video
Is signal processed correctly?
Is cable connected properly?
Video / PC selection window
Input signal guidance window
No signal
Current Input setting: RGB
Is signal processed correctly?
Is cable connected properly?
1