Keystone Correction - Eiki LC-XB43N Owner's Manual

Keystone Correction
If a projected picture still has keystone distortion after
pressing the AUTO SETUP/CANCEL button on the top
control or the AUTO SET/CANCEL button on the remote
control, correct the image manually as follows:
Press the KEYSTONE button on the top control or on
the remote control to switch the Standard (for Vertical/
Horizontal) /Corner adjustment. The Standard or Corner
adjustment dialog box appears. Use the Point
buttons to correct the Standard or Corner distortion. The
Standard or Corner adjustment can be stored (see page
50).
Standard
Reduce the lower width
with the Point button.
▼
Reduce the right part
with Point button.
►
Corner
Press the KEYSTONE button on the top control or on the
remote control to switch Corner adjustment, press the
SELECT button on the remote control to select the corner
you want to adjust.
Reduce the top left corner part
with the Point buttons.
►▼
Press the SELECT
button
Keystone
Press the SELECT
button
Press the SELECT
button
Keystone
Reduce the bottom left corner
part with the Point buttons.
►▲
▲▼◄►
Reduce the upper width
with the Point button.
▲
Reduce the left part with
Point button.
◄
Reduce the top right corner part
with the Point buttons.
◄▼
Keystone
Press the SELECT
button
Keystone
Reduce the bottom right corner
part with the Point buttons.
◄▲
Top Control
AUTO SETUP/CANCEL button
POINT ▲▼buttons
Remote Control
KEySTONE button
AUTO SET/CANCEL button
POINT ▲▼◄► buttons
Note:
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press and hold the KEYSTONE button for
more than 3 seconds while the Standard or Corner
dialog box is being displayed,
correction will be released
Corner
• The Corner pattern can be set to Off, Red, white or
Blue in the Corner pattern function. See "Keystone"
on page 50.
• The adjustable range is limited depending on the
input signal.
• Standard and Corner functions can not be adjusted
at the same time. If one of the functions is adjusted,
and then the other one will be reset automatically.
• The corner keystone function may be canceled when
you set the Auto keystone function to Auto or Manual.
To avoid this, it is recommended to set the Auto
keystone function to Off while the corner keystone
function is activated.
The top left corner adjustment as an example:
Press the Point ▼
button
Keystone
Keystone
Basic Operation
the
Standard or
.
Keystone
Press the Point ►
button