Clip Operations; Using The Clip Menu; Copying Clips - Canon EOS C100 Instruction Manual

Clip Operations

You can use the clip menu to copy* clips, delete clips, and convert* clips to standard definition. Clip menu
functions apply only to a single clip. Selecting the same functions from the [w Other Functions] > [Clips]
submenu, you can perform the same operations on multiple clips (selected clips or all clips).
* Original AVCHD clips in the clips index screen only.
Operating modes:

Using the Clip Menu

1 Select a clip and then press the joystick.
• The clip menu appears.
2 Select the desired function and then press the joystick.
3 Select [OK] and then press the joystick to perform the operation.
• Select [Cancel] instead to cancel the operation.
4 When the confirmation message appears, press the joystick.
IMPORTANT
• Observe the following precautions while either of the SD card access indicators is illuminated in red. Failure to
do so may result in permanent data loss.
- Do not disconnect the power source or turn off the camcorder.
- Do not open the SD card compartment cover and do not remove the SD cards.
NOTES
• When performing clip operations, make sure the LOCK switch on the SD cards used is not set to prevent
writing.

Copying Clips

You can copy clips from one SD card to the other.
Copying a Single Clip
1 Select the desired clip and then press the joystick to open the clip menu.
2 Select [Copy Clip] and then press the joystick.
3 Select [OK] and then press the joystick.
• Select [Cancel] instead to cancel the operation.
• While the clip is being copied, you can press the joystick to cancel.
4 When the confirmation message appears, press the joystick.
• The selected clip is copied to the other SD card and the screen changes back to the clip index screen.
Clip Operations
107