Attaching And Removing The Handle Unit - Canon EOS C100 Instruction Manual

Preparing the Camcorder
6 When the confirmation message appears, press the joystick.
IMPORTANT
• Be sure to observe the following precautions while the lens firmware is being updated.
32
- Do not disconnect the power source or turn off the camcorder.
- Do not remove the lens.
- Do not operate any buttons or controls on the camcorder.
- Do not open the SD card compartment cover and do not remove the SD cards.
NOTES
• The lens firmware cannot be updated while pre-recording is activated.
• We recommend that you power the camcorder from a household power outlet using the compact power
adapter or use a sufficiently charged battery pack.
• When using an optional EF Extender, remove the Extender before performing the procedure.

Attaching and Removing the Handle Unit

The handle unit extends the camcorder's audio capabilities, adding XLR terminals as well as a built-in stereo
microphone.
Attaching the Handle Unit
1 Set the Q switch to OFF.
2 Insert the attachment base at the bottom of the handle
unit to the camcorder's accessory shoe.
3 Tighten the handle unit's lock screw while gently pressing
it down.
4 Connect the handle unit's cable to the camcorder's EXT
terminal, aligning the
Removing the Handle Unit
1 Set the Q switch to OFF.
2 Disconnect the handle unit's cable.
• Pull back the metallic tip of the cable to release the
cable and then disconnect the cable from the terminal.
3 Loosen the handle unit's lock screw and gently slide out
the handle unit from the accessory shoe.
NOTES
• You can use the accessory shoe or the socket for 0.64 cm (1/4 in.) screws on the handle unit to attach a
variety of commercially available accessories.
Í
marks.