2. Ensure that the side of each filler overlaps the tab on the side of the system
To install fillers:
1. Turn Off the system and disconnect the EIA-232 power supply (if connected).
2. If you have a video display on an integrated system:
Figure 3. Installing the fillers for EIA-232 systems
4
4610- SJ6 Fiscal Printer User's Guide
unit.
See Figure 1 on page 2.
a. Move the display on its arm to the side and remove any tape holding the
alignment ring.
b. Remove the knockout section of the display filler.
c. Align the display filler with the alignment ring and slide the filler onto the
ring. Press the display filler into place. See Figure 3.