In addition to the supplied items, you may need:
•
T-10 Torx screwdriver
•
T-15 Torx screwdriver
To convert a tower server to a rack server:
Power down the server (on page 24).
1.
Disconnect all rear panel cabling
2.
Remove the tower bezel
3.
Remove the feet.
4.
Remove both tower configuration panels:
5.
Using the T-10 Torx screwdriver, remove the front panel screws.
a.
Unhook the tower configuration panels from the chassis.
b.
("Rear panel
components" on page 9).
("Open or remove the tower
bezel" on page 25).
Hardware options installation 88