Lenovo ThinkServer RD230 Hardware Maintenance Manual page 55
Machine types: 1043, 1044, 4010, and 4011
Hide thumbs
Also See for ThinkServer RD230:
- Hardware maintenance manual (164 pages) ,
- Benutzerhandbuch (144 pages) ,
- Manual d'utilisation (140 pages)
Table of Contents
Advertisement
Figure 20. Installing a 3.5-inch hard disk drive
6. Keep the handle on the hard disk drive tray assembly fully open, slide the tray with the hard disk drive
into the corresponding mounting point of the hot-swap hard disk drive bay (
the handle to lock the tray into place (
7. Check the hard disk drive status LEDs to make sure that the hard disk drive is operating correctly. You
might have to restart the server for the drive to be recognized. If the amber hard disk drive status LED
for a drive is lit continuously, it indicates that the drive is faulty and must be replaced; if the green hard
disk drive activity LED is flashing, this indicates that the drive is being accessed.
Note: If the server is configured for RAID operation using a RAID controller, you might have to
reconfigure the disk arrays after you replace hard disk drives.
8. To complete the installation, go to "Completing the parts replacement" on page 84.
2
).
Chapter 5
1
), and then slightly press
.
Installing, removing, or replacing hardware
49
Advertisement
Table of Contents
