Lenovo ThinkServer RD230 Hardware Maintenance Manual page 53

4. To complete the removal procedure, go to "Completing the parts replacement" on page 84.
Installing a hot-swap hard disk drive
Attention
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that comes with your product, and
Guidelines. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to install a hot-swap hard disk drive. This section applies only to
server models that support hot-swap hard disk drives.
Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without
either a drive or a filler panel installed in each drive bay.
Important: Before you install optional hardware devices, make sure that the server is working correctly. If
the server is not working correctly, refer to theDiagnostics for your server for detailed diagnostic information.
To obtain the publication, go to:
http://www.lenovo.com/support
To install a hot-swap hard disk drive, do the following:
Notes:
1. You do not have to turn off the server for the installation of a hot-swap hard disk drive.
2. The cables come with the SATA hard disk drive option kit will not be used in this server.
1. Rotate the drive tray handle
the handle and pull the drive tray assembly out of the bay.
Figure 18. Removing the hard disk drive tray assembly
2. Remove the screws that secure the plastic filler and then remove the plastic filler.
2
of the hard disk drive tray assembly
1
to the open position. Then, grasp
.
Chapter 5 Installing, removing, or replacing hardware
47