Lenovo ThinkServer RD230 Hardware Maintenance Manual page 33

• The SGPIO connector of the 4–port SATA cable in the chassis should be connected to the J45 connector
on the system board. See "Locating parts on the system board" on page 28.
• The function of the Amber LED 2 is only available after you enter the operating system.
Table 4. Hard disk drive LEDs
Hard disk drive is not present.
Hard disk drive is present but is not active.
Hard disk drive is present and active.
Server is in the process of locating the hard disk drive.
RAID has failed.
Hard disk drive is rebuilding.
Note: For some models, the hard disk drive status information might be different from the information listed in
the above table. For these server models, refer to the following two tables for the hard disk drive LED status.
Table 5. Hard disk drive LEDs for the onboard SATA and onboard SATA software RAID configurations (some models)
Hard disk drive is not present.
Hard disk drive is present but is not active.
Hard disk drive is present and active.
Server is in the process of locating the hard disk drive.
RAID has failed.
Hard disk drive is rebuilding.
Table 6. Hard disk drive LEDs for the add-on SAS RAID adapter configuration (some models)
Hard disk drive is not present.
Hard disk drive is present but is not active.
Hard disk drive is present and active.
Server is in the process of locating the hard disk drive.
RAID has failed.
Hard disk drive is rebuilding.
The Ethernet 1 and Ethernet 2 connectors have two status LEDs that indicate the LAN connection and
activity of the connection.
Description
Description
Description
Green LED 1
(bottom)
Off
On
Blinking
On
Off
Blinking
Green LED 1
(bottom)
Off
On
Blinking
On
On
Blinking
Green LED 1
(bottom)
Off
On
Blinking
Blinking
Off
Blinking
.
Chapter 4 Locating parts, controls, LEDs, and connectors
Amber LED 2 (top)
Off
Off
Off
Blinking
On
Blinking
Amber LED 2 (top)
Off
Off
Off
Off
Off
Off
Amber LED 2 (top)
Off
Off
Off
Blinking
On
Blinking
27