Lenovo ThinkServer RD230 Hardware Maintenance Manual page 114

Table 31. Submenus under the Hardware Health Configuration (continued)
Item
H/W Health Function
Auto FAN Control
PWM Minimal Duty Cycle
Fan Failure LED Indication
Hardware Health Event Monitoring
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 32. Submenus under the IPMI 2.0 Configuration
Item
View BMC System Event
Log
Clear BMC System Event
Log
Set LAN Configuration
Set PEF Configuration
BMC Watch Dog Timer
Action
BMC Alert LED and Beep
FW key
Note: The settings in [ ] are the default settings in the Setup Utility program.
108
ThinkServer RD230 Hardware Maintenance Manual
Option
Disabled[Enabled]
Disabled[Enabled]
[60% Duty Cycle]45% Duty Cycle30%
Duty Cycle
Disabled[Enabled]
Read Only
Sub-item
PEF SUPPORT
Enable or disable the hardware
monitor function.
If this option is set to Disabled, the
fan runs at the full speed; if this option
is set to Enabled, the fan speed is
controlled by the system temperature.
Select the PWM Minimal Duty Cycle
for the fan: 60%-100%, 45%-100%,
or 30%-100%.
Enable or disable the fan alarm
function. If this option is set to
Enabled, a message about fan failure
will be displayed on the POST screen
when the rotational speed of each fan
is less than 800 rpm.
The sensor data in this option is for
read only. The detected data includes
the temperature and system fan
rotational speed.
Option
Disabled[Enabled]
[Disabled]Reset
SystemPower DownPower
Cycle
[Off]On
[0000000]
Description
Description
View the system event log.
Delete the system event
log.
Set the IP address source,
IP address, subnet mask,
and gateway address.
Enable or disable the PEF
support.
Disable or enable the OS
based dongle. If enabled,
whenever any problems
arising from the operation
system, such as the
system halted, the system
management feature will
take actions of Reset
System, Power Down, or
Power Cycle at the prompt
of the dongle Timer.
Turn on or turn off the BMC
alert LED and beep.