Lenovo ThinkServer RD230 Hardware Maintenance Manual page 116

Table 36. Items under the Boot menu
Item
Boot Settings Configuration
Boot Device Priority
Hard Disk Drives
CD/DVD Drives
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 37. Items under the Security menu
Change Supervisor Password
Change User Password
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 38. Items under the Chipset menu
Item
CPU Bridge Configuration
110
ThinkServer RD230 Hardware Maintenance Manual
Sub-item
Quick Boot
Quiet Boot
AddOn ROM Display Mode
Bootup Num-Lock
1st Boot Device
2nd Boot Device
1st Drive2nd Drive...
1st Drive...
Item
Sub-item
QPI Frequency
QPI L0s and L1
Memory Frequency
Memory Mode
Option
[Disabled]Enabled
[Enabled]Disabled
[Force BIOS]Keep Current
[Off]On
Boot device names
Boot device names
Description
Set or change the supervisor password. The password
can be any combination of up to 6 (1 to 6) alphabetic and
numeric characters.
Set or change the user password. The password can
be any combination of up to 6 (1 to 6) alphabetic and
numeric characters.
Option
[Auto]4.800GT5.866GT6.400GT S tandard transferring rate
Disabled[Enabled]
[Auto]Force DDR-800Force
DDR-1066Force DDR-1333
[Independent]Channel
MirroringLockstep
Description
Enable or disable the quick
boot feature.
Enable or disable the
feature to show OEM Logo
during the POST.
Set the AddOn ROM
Display Mode.
Set the Num-Lock LED
state.
Set the startup device
sequence (support at most
five startup devices).
Based on the installed hard
disk drives.
Based on the installed
optical drives.
Description
of the QPI bus.
Enable or disable the QPI
L0s and L1.
Set the frequency of the
memory module. Make
sure that the mandatory
memory frequency setting
is less than the maximum
frequency that the memory
module can support.
Set the memory channel
mode to improve reliability
or efficiency.