NEC N8100-1668F User Manual page 320

8-38 Troubleshooting
There are some cases that an event log is registered as follows when you operate
Windows Server 2003 R2:
Source: IPMIDRV
Type: Error
Event ID: 1001
Description: The IPMI device driver attempted to determine if the system supported an IPMI BMC
device. The driver attempted to detect the presence of the IPMI BMC by searching the
SMBIOS for Type 38 record. But either no record was found or the record was not
compatible with the version of the device driver.
If a SMBIOS Type 38 record was detected, the Dump Data field of the event contains
a binary representation of the record.
If you use "Hardware Management" which is provided by Windows Server 2003
→
R2, above-shown event log will be registered.
For more details, refer to "Enabling Microsoft Windows Server 2003 R2
Hardware Management" on the following site.
[NEC Express5800 Web Site]
http://www.nec.co.jp/express/download/W2K3_R2
The system displays the message below and fails to log on:
Windows Product Activation
This copy of Windows must be activated with Microsoft before you can
continue. You cannot log on until you activate Windows.
To shut down the computer, click Cancel.
In Windows Server 2003, the above message will be displayed if you use the
→
operating system without executing the license authentication. Select "Yes", and
execute the procedure for license authentication.
Cannot install the operating system correctly:
Did you confirm the notes on installing the operating system?

See Chapter 6.
→
YES NO Cancel