NEC N8100-1668F User Manual page 295

Displayed Error Message
8001 Real time clock error
8002 Check date and time
settings
8003 System battery is dead -
Replace and run SETUP
8005 Previous boot incomplete
- Default configuration
used
8006 System configuration
data cleared by Jumper.
8007 SETUP Menu Password
cleared by Jumper.
8010 Graphics controller was
not detected.
8800 DXE_NB_ERROR
8801 DXE_NO_CON_IN
8802 DXE_NO_CON_OUT
8803 PEI_DXE_CORE_NOT_
FOUND
8804 PEI_DXEIPL_NOT_FOU
ND
8805 DXE_ARCH_PROTOCO
L_NOT_AVAILABLE
8806 PEI_RESET_NOT_
AVAILABLE
8807 DXE_RESET_NOT_
AVAILABLE
Description
Real-time clock error
The real-time clock time
setting is incorrect.
There is no system battery.
The last time the system was
started up, POST processing
did not finish.
The BIOS setup utility
settings were cleared using
the jumper.
The BIOS setup utility menu
password was cleared using
the jumper.
No graphics controller was
detected.
An error was detected during
chip set initialization.
An error was detected during
console initialization.
A Flash ROM failure was
detected.
The system was not reset
correctly.
Troubleshooting 8-13
Recommended Action
Start up the BIOS setup
utility, and then specify the
correct date and time. If the
same error continues to
occur, contact your service
representative.
Contact your service
representative to request
battery replacement. (After
the replacement, start up the
BIOS setup utility, and then
specify the correct settings.)
Use the BIOS setup utility to
specify the correct settings.
Specify the BIOS setup utility
settings again.
Use the BIOS setup utility to
specify another password.
Contact your service
representative.