Attributes; V1/V2C Communities; V3 Users - HP MSM3xx Management And Configuration Manual

Attributes

System name
Specify a name to identify the AP. By default, this is set to the placeholder %serial
number%, which is automatically replaced with the serial number of the AP.
Location
Specify a descriptive name for the location where the AP is installed.
Contact
Contact information for the AP.
Port
Specify the UDP port and protocol the AP uses to respond to SNMP requests. Default port is
161.
SNMP protocol
Select the SNMP versions that the AP will support. Default is Version 1 and Version 2c.
Notifications
When this feature is enabled, the AP sends notifications to the hosts that appear in the
Notifications receivers list.
The AP supports the following MIB II notifications:
 coldStart
 linkUp
 linkDown
 authenticationFailure
In addition, the AP supports a number of custom notifications. Select Configure
Notifications. For a descriptions of these notifications, see the online help.

v1/v2c communities

Community name
Specify the password, also known as the read/write name, that controls read/write access to
the SNMP agent. A network management program must supply this name when attempting to
set or get SNMP information from the AP. By default, this is set to private.
Read-only name
This is the password that controls read-only access to SNMP agent. A network management
program must supply this name when attempting to get SNMP information from the AP. By
default, this is set to public.

v3 users

This table lists all defined SNMP v3 users. To add a new user, select Add New User. Up to
five users are supported. To edit a user, select its link in the Username column.
Username
The SNMP v3 username.
Management
SNMP
2-9