Removing And Replacing The Server Top Cover - Cisco UCS C240 M4 Installation And Service Manual

Preparing for Server Component Installation

Removing and Replacing the Server Top Cover

Step 1 Remove the top cover (see
a.
b.
c.
Step 2 Replace the top cover:
Note
a.
b.
c.
Cisco UCS C240 M4 Server Installation and Service Guide
3-10
Figure
If the cover latch is locked, use a screwdriver to turn the lock 90-degrees counterclockwise to unlock
it. See Figure 3-4.
Lift on the end of the latch that has the green finger grip. The cover is pushed back to the open
position as you lift the latch.
Lift the top cover straight up from the server and set it aside.
The latch must be in the fully open position when you set the cover back in place, which allows
the opening in the latch to sit over a peg that is on the fan tray.
With the latch in the fully open position, place the cover on top of the server about one-half inch
(1.27 cm) behind the lip of the front cover panel. The opening in the latch should fit over the peg
that sticks up from the fan tray.
Press the cover latch down to the closed position. The cover is pushed forward to the closed position
as you push down the latch.
If desired, lock the latch by using a screwdriver to turn the lock 90-degrees clockwise.
3-4).
Chapter 3 Maintaining the Server
OL-32474-01