Storage; Storing The Cleaner - Hoover FloorMate SpinScrub 800 Owner's Manual

39
A
A
40
B
41
E
C
F
D
M
42
K
J
N
L
The handle must be in the upright position in order
to get cleaning solution through the hose.
NOTE: It may be necessary to remove air from the system
(prime the pump) so the clean solution will flow to the tool.
After attaching the tool to the hose, turn the cleaner ON. Put the
tool against your hand to block off the suction. Wait a few sec-
onds, then squeeze the trigger and begin cleaning.
Using the tool
39
Let go of trigger and pull tool over same area to pick
up dirty solution without putting down more solution.

Storing the cleaner

Before storing cleaner:
Turn cleaner OFF and disconnect from electrical outlet.
• Empty and rinse solution and recovery tanks. Allow to air
dry.
• Press on upper handle release button to lower handle for

storage.

• Make sure that nothing is pressing on the nozzle squeegee.
• Do not store cleaner on a wood surface unless cleaner is
completely dry.
Tool caddy
G
40
H
the hose, tools, telescoping wand, set of brushes and
detergent.
The two sections of the tool caddy snap together for assembly.
Press where indicated by arrows to snap securely in place. The
I
caddy conveniently fits over the top of the cleaner nozzle (B)
for storage.
41
(E). Continue wrapping hose down, underneath tongue (F),
and back up, pressing into second cut-out area (G). Place hose
end (H) into slot (I) on back of caddy.
N
42
as shown.
Squeeze and hold trigger (A) in hose grip to release
cleaning solution.
For your convenience, the HOOVER® FloorMate™
SpinScrub™ 800 tool caddy (A) is provided for storing
To store hose: Place the hose grip (C) into slot (D) on
back of caddy. Pull hose up and press into cut-out area
Place floor swivel tool (J), grout tool (K), brush assembly
(L), telescoping wand (M) and detergent (N) into caddy
Continued
15