Related Manuals for Hoover FloorMate SpinScrub 800
Summary of Contents for Hoover FloorMate SpinScrub 800
- Page 1 FloorMate™ SpinScrub™ 800 Hard Floor Cleaner ENGLISH pp. 1-20 ESPAÑOL pág. 21-36 FRANÇAIS p. 37-52 ®...
-
Page 2: Important Safeguards
If appliance is not working as it should, has been dropped, dam- aged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer. • Use cleaner only for its intended use as described in the instructions. -
Page 3: Table Of Contents
To contact us: • www.hoover.com • 1-800-944-9200 - automated service dealer locator • 1-330-499-9499 - our Consumer Response Center (8 AM to 5 PM Monday - Friday) Fill in and Save For your records, enter the model number and serial numbers in the spaces provided. These numbers are located on the data label on the back of the cleaner body. -
Page 4: Cleaner Description
Cleaner Description Features Soft hand grip ON/OFF switch Solution trigger: squeeze to release cleaning solution Mode selector dial: turns brushes ON for wet cleaning and OFF for wet pickup and dry vacuuming Clean solution tank cap/measuring cup Clean solution tank Clean solution tank release Recovery tank release Recovery tank lid and filter... -
Page 5: Assembly Handle Assembly
Assemble handle Rotate bottom handle support (A) up to the upright position until a snap is felt. Align control rod (B) on upper handle (C) with slot in bottom handle support (D). Push upper handle (C) down until it is snapped in place. Install brushes and nozzle To install brushes, place handle in upright position. - Page 6 Press brush assembly firmly to snap into place. To install nozzle, make sure latches (C) are out. Align middle section (D) of nozzle with opening (E) on cleaner. Remove cardboard packing insert from squeegee area on underside of nozzle. While holding nozzle in place, slide latches inward to lock in place.
-
Page 7: Unfold Handle
Store hose, tools and accessories To store hose: Place the hose grip (D) into slot (E) on back of caddy. Pull hose up and press into cut-out area (F). Continue wrap- ping hose down, underneath tongue (G), and back up, pressing into second cut-out area (H). Place hose end (I) into slot (J) on back of caddy. -
Page 8: General Operation
(A) on the front of the cleaner. General operation Your HOOVER FloorMate™ SpinScrub™ 800 Cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile, marble and sealed wood. It is not intended for use on carpet or rugs. -
Page 9: Solution Tank
DO NOT use cleaning concentrates that contain solvent based ingredients. CAUTION: HOOVER® Floor to Floor™ Cleaning Concentrate and HOOVER® Grout Cleaner cannot be used in Hoover SteamVac™ products. Doing so could damage your SteamVac™ Cleaner. The tanks Solution (upper) tank The solution tank holds detergent and water that is to be dispersed onto the surface being cleaned. -
Page 10: Recovery Tank
If rubber ring (D) on cap has become dislodged, reposi- tion it with uneven side against ledge (E) as shown. Replace cap. Rotate cap clockwise until it locks in place. Cap must be locked in place for proper performance and to prevent leaking. Slide tank straight into position until latch snaps in place. -
Page 11: To Clean Filters
How to empty Turn cleaner off and disconnect from electrical outlet. Although not necessary for satisfactory performance, it is recommended that the recovery tank be emptied after dry vacuuming and before wet operation. Check the solution tank also. It may need to be refilled at this time. -
Page 12: How To Clean
How to clean Recommended cleaning sequence Use your HOOVER® FloorMate™ SpinScrub™ 800 Cleaner to: • Dry Vacuum to remove loose dirt, hair and debris. • Wet Clean the floor surface. The brushes will provide light agitation to help loosen dirt. -
Page 13: Cleaning Floors
Cleaning floors NOTE: Your HOOVER® FloorMate™ SpinScrub™ 800 cleaner may be used to clean wood floors that have been sealed with a polyurethane coating and can be cleaned with water. CAUTION: To prevent damage to wood floors, follow the flooring manufacturer’s cleaning rec- ommendations. -
Page 14: Select Tool
Using the tools Select tool A. Floor swivel tool • Swivel head • 2 rows of brushes • Use to clean small, tight areas B. Grout tool • Stiff brushes to use for more concentrated cleaning on stubborn grout stains Attach hose and tool Unplug cleaner from electrical outlet. -
Page 15: Storage
Tool caddy For your convenience, the HOOVER® FloorMate™ SpinScrub™ 800 tool caddy (A) is provided for storing the hose, tools, telescoping wand, set of brushes and detergent. The two sections of the tool caddy snap together for assembly. -
Page 16: Maintenance Cleaning The Nozzle
Maintenance Cleaning the nozzle Turn cleaner OFF and disconnect from electrical outlet. The cleaner’s nozzle can be removed for easy cleaning. Slide the two nozzle release latches (A) outward. Remove nozzle (B) by pulling straight out. Rinse nozzle under running water. Remove debris from squeegee (C) and wipe with a damp cloth. -
Page 17: Cleaning The Brushes
Cleaning the brushes The brush assembly can be removed for easy cleaning. Turn cleaner OFF and disconnect from electrical outlet. Place handle in the upright position. Remove tanks to prevent leaking. Set aside. Pull the two nozzle release buttons (A) out. Remove nozzle. Tilt cleaner back so handle rests on floor. -
Page 18: Troubleshooting
Troubleshooting Use the list below to help solve minor problems. What’s the problem? Cleaner won’t run Low suction Water puddling behind cleaner Won’t pick up dirty solution Cleaner pushes a line of dry debris in front of it Cleaning solution won’t dispense Brushes won’t rotate What to do Make sure the cleaner is... -
Page 19: Service
Calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) Do not send your cleaner to The Hoover Company in North Canton for service; this will only result in delay. If further assistance is needed, contact The Hoover Company Consumer Response Center, Phone: 330-499-9499. -
Page 20: Warranty
Full One Year Warranty (Domestic Use) Your HOOVER® appliance is war- ranted in normal household use, in accordance with the Owner’s Manual against original defects in material and workmanship for a period of one full year from date of purchase. This warranty provides, at...