Installation Instructions - Chicago Electric 66603 Set Up, Operating, And Servicing Instructions

to the Battery Guard Plate, using two Bolts with Lock Washers (46).
(see Figure b.)
NEGATIvE bATTERY cAblE
12 vDc bATTERY
bATTERY bRAcKET (47)
bolT wITh locK wAshER (46)
6. Connect the Engine's Positive Battery Cable (RED +) to the Battery's positive (+)
terminal. Then connect the Engine's Negative Battery Cable (BLACK --) to the
Battery's negative (--) terminal. (see Figure b.)
1. With additional assistance, and a proper lifting device, raise the left side of the
Generator about 6 to 8 inches off the floor surface.
2. Attach the two Axle Brackets (53) to the lower Frame (42), using two Bolts (52) and
two Lock Washer Nuts (13) for each Axle Bracket (see Assy. Diagram).
3. Slide the Axle (49) through the two Axle Brackets (53).
4. Insert one Wheel (50) onto each end of the Axle (49).
5. Secure the Axle (49) and Wheels (50) in place, using four Pins (51).
(see Assy. Diagram.)
1. IMpoRTANT:
emergency or portable power systems. Make sure to investigate the local building
and electrical codes before installing this unit.
2. Locate the Generator (outdoors only) where cooling air is readily available. Locate
the Generator so that the air inlets and outlets are not blocked by obstructions
such as bushes, trees, walls, snow drifts, etc. Locating the Generator in the path
SKU 66603 For technical questions, please call 1-800-444-3353.
FIGURE b
(NoT INclUDED)
To ATTAch ThE whEEl AssEMblY

INsTAllATIoN INsTRUcTIoNs

Electrical and other permits may be required for the installation of
posITIvE bATTERY cAblE
bATTERY GUARD plATE (44)
bATTERY TRAY (48)
(see Assy. Diagram.)
(see Assy. Diagram.)
Page 11