Page 1
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
SKU 65309 For technical questions, please call 1-800-444-3353. nOTice is used to address practices not related to personal injury. cauTiOn, without...
Page 3
Control Panel. Con- nect this wire to a suitable external ground, such as a metal stake in the ground. SKU 65309 For technical questions, please call 1-800-444-3353. Don’t overload the generator. The total wattage used by the devices should be less than the output rating of the generator.
Caution is neces- sary when near the engine’s magneto or recoil starter. Use only accessories that are recom- mended by Harbor Freight Tools for your model. Accessories that may be suitable for one piece of equipment may become hazardous when used on another piece of equipment.
(See Table a.) If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to SKU 65309 For technical questions, please call 1-800-444-3353. indicate it is acceptable for outdoor use.
(sold separately) be- tween this generator and the devices. Maintain labels and nameplates on the equipment. These carry impor- tant information. If unreadable or missing, contact Harbor Freight Tools for a replacement. Store equipment out of the reach of children. Save TheSe inSTRucTiOnS.
Single 125/250 v~ Receptacle and circuit breakers. Use a 4-blade grounded connector to operate 125/250 V~, 60 Hz, single phase SKU 65309 For technical questions, please call 1-800-444-3353. loads requiring up to 50 Amps of current up to 12,000 Watts (12kW) of Each cir- power.
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. Included components:...
Page 9
Generator. Minimizing vertical angles reduces friction, heat and wear on the U-joints of the PTO shaft. SKU 65309 For technical questions, please call 1-800-444-3353. Attach the generator to the tractor us- ing all 3 connection points and appro- priate hardware (not included).
Engage the tractor PTO drive. Set the tractor’s PTO speed to 540 RPM. SKU 65309 For technical questions, please call 1-800-444-3353. Test each GFCI outlet by pressing the TEST button. The green light on that outlet should go out.
Stopping the Generator Turn OFF all attached devices. Unplug the cords from the Generator. Turn OFF the tractor engine. SKU 65309 For technical questions, please call 1-800-444-3353. Page 11...
Check for missing, cor- roded or loose fasteners. Be sure all SKU 65309 For technical questions, please call 1-800-444-3353. shields and guards are in good condi- tion. Inspect for general condition and cleanliness.
Page 13
Fill Plug (31) to help the oil to drain. Catch the draining oil in a suitable container. Dispose of the used oil properly. SKU 65309 For technical questions, please call 1-800-444-3353. After all the used oil has drained, replace and tighten the Oil Drain Plug (21).
Page 14
Cover and store in a dry, well-ventilat- ed area out of reach of children. For cold weather operation, store the equipment in a cool dry area to prevent condensation and premature wear. SKU 65309 For technical questions, please call 1-800-444-3353. Page 14...
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 65309 For technical questions, please call 1-800-444-3353. equipment Troubleshooting...
Seal m35 x 72 x 8 Washer m72 Output Shaft Sealed Bearing 6306-2Z Gasket Gearbox Cover Plate Oil Level Plug Gearbox Oil Fill Plug SKU 65309 For technical questions, please call 1-800-444-3353. PaRTS LiST q’ty Part description Control Panel Frame Control Panel Window...
LiMiTed 1 YeaR / 90 daY WaRRanTY Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that for a period of ninety days from date of purchase that the engine/motor, the belts (if so equipped), and the blades (if so equipped) are free of defects in materials and workmanship.