Windows 98Se/Me - StarTech.com PCISAT2IDE1 Instruction Manual

Windows 98SE/ME

1. Following card installation, Windows will detect the presence of the card and initiate
the software installation process.
2. Windows will detect the VIA SATA PCI Controller and launch the Add New Hardware
Wizard. Select Specify the location of the driver (Advanced) and click Next to
continue setup.
3. Insert the Driver CD into the CD/DVD-ROM drive, then select Search for the best
driver for this device (Recommended). Enter D:\WIN9X in the field designating the
file location, and press Next to continue setup.
4. Windows will detect the driver for VIA VT6421 RAID Controller. Press Next to
continue setup.
5. Once driver installation has finished, click on Finish to continue.
6. When asked to do so, please reboot the computer for the driver installation to take
effect.
Verifying driver installation
Once Windows has been rebooted following the installation of the drivers, verify that the
card is properly installed by browsing to the Device Manager within the Windows
Control Panel, and click on the [+] symbol next to SCSI and RAID Controllers. Here,
you should see VIA VT6421 RAID Controller listed, if the installation was successful:
Instruction Manual
4