Modifying The Network Settings - Eaton Managed ePDU User Manual

USING THE WEB INTERFACE
76
EATON Managed ePDU
2. Type a new name in the Device Name field.
3. If DHCP is selected for IP configuration, the name entered in the field or
Preferred Host Name (DHCP only) will be registered with DNS and used on the
assigned IPs by DHCP.
4. Click Apply. The ePDU is renamed.

Modifying the Network Settings

The ePDU was configured for network connectivity during the installation and
configuration process (see Chapter 4, Installation and Configuration" for details). If
necessary, you can modify any of these settings. To do this:
1. Select Device Settings, and then select Network. The Network Settings page
displays. The left side of the page consists of the Basic Network Settings panel,
which displays the current network settings (see Figure 73).
2. Do one of the following:
S
Auto configuration: To auto configure the ePDU, select DHCP or BOOTP from the
IP Auto Configuration list. If you select DHCP, you can also enter a preferred
host name (this is optional).
S
Static IP: To enter a static IP address, select None from the IP Auto Configuration
list, and then enter:
IP address
Subnet mask
Gateway address
Primary and (optional) secondary DNS server addresses
3. Click Apply. The network settings are modified.
t S
164201xxx Rev 1 DRAFT 10−OCT−2008
User's Guide